RPi.GPIO : NanoPi NEO/NEO2/Air GPIO Programming with Python

查看中文

1 Introduction to RPi.GPIO_NP

For users to easily access GPIO with python FriendlyElec integrated RPi.GPIO in the UbuntuCore images for the NanoPi NEO/NEO2.
RPi.GPIO is a famous library in python for Raspberry Pi. FriendlyElec ported it to the NanoPi NEO/NEO2's UbuntuCore images and renamed it as RPi.GPIO_NP.
Most RPi.GPIO_NP's APIs are the same as those of RPi.GPIO and you can refer to https://pypi.python.org/pypi/RPi.GPIO for more details.

2 Install RPi.GPIO_NP

The RPi.GPIO_NP library is integrated in all the UbuntuCore images that are and will be released after June 5, 2017. Therefore for images released after this date no installation is needed.

3 Code Sample with RPi.GPIO_NP

Here is code sample on how to access a NanoPi NEO2. A Matrix - LED is connected to a NanoPi NEO2 in the following hardware setup:

Pin Connection:

Matrix-LED	NanoPi NEO2
S	Pin7
V	Pin4
G	Pin6

The code sample shows how to make an LED blink in Python
Pin 7 is accessed in this code sample:

3.1 Code Sample in Python

Create a source file in Python:

vi led.py

Type in the following lines:

#!/usr/bin/env python
import RPi.GPIO as GPIO
import time
PIN_NUM = 7
 
GPIO.setmode(GPIO.BOARD)
GPIO.setup(PIN_NUM,GPIO.OUT)
while True:
        GPIO.output(PIN_NUM,True)
        time.sleep(1)
        GPIO.output(PIN_NUM,False)
        time.sleep(1)

Run led.py：

chmod +x led.py
sudo ./led.py

The LED module will blink if you do everything right.

4 Update Log

4.1 June-7-2017

• Released English Version