Difference between revisions of "Template:OfficialUbuntuCore"

From FriendlyELEC WiKi
Jump to: navigation, search
(updated by API)
(updated by API)
Line 30: Line 30:
 
eth1: 192.168.2.1<br/>
 
eth1: 192.168.2.1<br/>
 
eth2: 192.168.3.1 (Note: if there are three network ports)<br/>
 
eth2: 192.168.3.1 (Note: if there are three network ports)<br/>
 +
| NanoPi-R5C =
 +
The other ethernet port are set up with static IP addresses, as follows:<br/>
 +
eth1: 192.168.2.1<br/>
 
  | #default =
 
  | #default =
 
}}
 
}}
Line 72: Line 75:
 
  | NanoPi-R2S
 
  | NanoPi-R2S
 
  | NanoPi-R2C-Plus
 
  | NanoPi-R2C-Plus
 +
| NanoPi-R5C
 
  | NanoPi-R2C =
 
  | NanoPi-R2C =
 
===Config status LEDs===
 
===Config status LEDs===

Revision as of 09:21, 17 November 2022

1 Work with FriendlyCore

1.1 FriendlyCore User Account

  • Non-root User:
   User Name: pi
   Password: pi
  • Root:
   User Name: root
   Password: fa

1.2 Update Software Packages

$ sudo apt-get update

1.3 Setup Network Configurations

1.3.1 Set static IP address

By default "eth0" is assigned an IP address obtained via dhcp. If you want to change the setting you need to change the following file:

vi /etc/network/interfaces.d/eth0

For example if you want to assign a static IP to it you can run the following commands:

auto eth0
iface eth0 inet static
    address 192.168.1.231
    netmask 255.255.255.0
    gateway 192.168.1.1

1.3.2 Set a DNS

You also need to modify the following file to add the DNS configuration:

vi /etc/systemd/resolved.conf

For example, set to 192.168.1.1:

[Resolve]
DNS=192.168.1.1

Restart the systemd-resolved service with the following command:

sudo systemctl restart systemd-resolved.service
sudo systemctl enable systemd-resolved.service

1.3.3 Set up to use another network interface

To change the setting of "eth1" you can add a new file similar to eth0's configuration file under the /etc/network/interfaces.d/ directory.

1.4 Install the kernel-header package

sudo dpkg -i /opt/linux-headers-*.deb