Matrix - LED

From FriendlyELEC WiKi
Revision as of 07:37, 7 August 2015 by Yftan (Talk | contribs) (Introduction)

Jump to: navigation, search

查看中文

1 Introduction

LED
LED
LED

On this module we put a 5mm LED and extend a 3-Pin 2.54mm spacing pin header. Pin V is power, G is grounded and S is data which is connected to a triode to turn the LED on or off. You can write high or low, or PWN signals(3.3V or 5V) to S. When you write high to S the LED will turn on and its brightness will be the strongest. When you write low to S the LED will turn off. If you write PWM signals to S the LED's brightness will vary. We provide red, green and white LED modules.

2 Features

  • GPIO/PWM interface, 3.3/5V, PWM brightness control
  • Tiny, easy to be used in various situations
  • 2.54mm spacing pin

3 How To

3.1 Connection

  • Connect to Tiny4412 SDK (1506)
Connect the module's pin S to GPIO PIN1, V to 5V and G grounded

3.2 Code Sample in C Under Linux

#include <stdio.h>
#include <unistd.h>
#include "libfahw.h"
 
#define LED_BLINK_TIMES     10
 
int main(int argc, char ** argv)
{
    int ledPin = TINY4412_GPIO_PIN1;
    int i = 0;
    int ret = -1;
 
    if ((ret = exportGPIOPin(ledPin)) == -1) {
        printf("exportGPIOPin(%d) failed\n", ledPin);
    }
    if ((ret = setGPIODirection(ledPin, GPIO_OUT)) == -1) {
        printf("setGPIODirection(%d) failed\n", ledPin);
    }
 
    for (i = 0; i < LED_BLINK_TIMES; i++) {
        if (i % 2) {
            ret = setGPIOValue(ledPin, GPIO_HIGH);
        } else {
            ret = setGPIOValue(ledPin, GPIO_LOW);
        }
        if (ret == -1) {
            printf("setGPIOValue(%d) failed\n", ledPin);
        }
        printf("LED blinking times %d\n", i);
        sleep(1);
    }
    unexportGPIOPin(ledPin);
    return 0;
}

3.3 Compile and Run

git clone http://github.com/friendlyarm/fa-hardware.git
cd fa-hardware
cd demo
cd matrix-led
make

Copy your compiled bin to your board and you are ready to go.

4 Resources