Difference between revisions of "Matrix - Button"
From FriendlyELEC WiKi
(→Introduction) |
(→特性) |
||
| Line 5: | Line 5: | ||
The Matrix-Button is an instant(non self-lock) button. The button's status can be read from pin S in the 3-pin 2.54 mm spacing pin header. If the button is not pressed S will output high otherwise S will output low. | The Matrix-Button is an instant(non self-lock) button. The button's status can be read from pin S in the 3-pin 2.54 mm spacing pin header. If the button is not pressed S will output high otherwise S will output low. | ||
| − | == | + | ==Features== |
| − | * | + | * Instant, non self-lock |
| − | * | + | * Tiny, easy to be used in various situations |
| − | * 2. | + | * 2.54mm spacing pin |
==使用方法== | ==使用方法== | ||
Revision as of 07:03, 7 August 2015
1 Introduction
The Matrix-Button is an instant(non self-lock) button. The button's status can be read from pin S in the 3-pin 2.54 mm spacing pin header. If the button is not pressed S will output high otherwise S will output low.
2 Features
- Instant, non self-lock
- Tiny, easy to be used in various situations
- 2.54mm spacing pin
3 使用方法
3.1 连接
- 连接到Tiny4412 SDK (1506)
- 将配件S针脚连接到GPIO PIN1, V接5V，G接地
3.2 Linux下的C示例
#include <stdio.h> #include "libfahw.h" static struct sensor button[] = { { TINY4412_GPIO_PIN1, IRQ_TYPE_EDGE_FALLING, } }; int main(void) { int i; int retSize = -1; char value[ARRAY_SIZE(button)]; int devFD = -1; if ((devFD =sensorInit(button, ARRAY_SIZE(button))) == -1) { printf("Fail to init sensor\n"); return -1; } printf("Press the button...\n"); if (( retSize = sensorRead(devFD, value, ARRAY_SIZE(button)) ) == -1) { printf("Fail to read sensors\n"); } if (retSize > 0) { i = 0; for (i=0; i<retSize; i++) { printf("Button[%d]:%d\n", i, value[i]); } } sensorDeinit(devFD); return 0; }
3.3 编译并运行示例
git clone http://github.com/friendlyarm/fa-hardware.git cd fa-hardware cd demo cd matrix-button make
将编译生成的button通过ftp上传到开发板上运行即可测试。
