LED

查看中文

H3/H5

The onboard status LEDs are all heartbeat status by default, and you can check the relevant settings with the following command：

$ cat /sys/class/leds/status_led/trigger
none rc-feedback rfkill-any kbd-scrolllock kbd-numlock kbd-capslock kbd-kanalockk
 kbd-shiftlock kbd-altgrlock kbd-ctrllock kbd-altlock kbd-shiftllock kbd-shiftrll
ock kbd-ctrlllock kbd-ctrlrlock usbport usb-gadget usb-host mmc1 mmc2 mmc0 timerr
 oneshot disk-activity ide-disk mtd nand-disk [heartbeat] backlight gpio cpu cpuu
0 cpu1 cpu2 cpu3 default-on transient flash torch panic netdev rfkill0 stmmac-0::
00:1Gbps stmmac-0:00:100Mbps stmmac-0:00:10Mbps

[heartbeat]means that the default triggering mode of the LED is heartbeat.
Example: Execute the following command to keep the LED always on：

echo default-on > /sys/class/leds/status_led/trigger