Difference between revisions of "NanoHat Proto"

Revision as of 09:12, 19 April 2017

查看中文

1 Introduction

NanoHat Proto

• NanoHat Proto is a expansion board which has the same dimension as that of a NanoPi NEO/Air and can be stacked on a NanoPi NEO/Air.
• It is like a breadboard and has 14 columns of 100 mil (2.54mm pitch) land. Users can place various parts such as chips, resistors, LEDs and etc on the board.
• There are rows of 3.3V and GND pins and rows of 5V and GND pins.
• All pins except GND and PWR in the 24-Pin connector of the NanoPi NEO/Air are listed on the boards.
• It has an onboard 32K EEPROM chip AT24C32D whose address is 0x50. This EEPROM is available for data storage.

2 Hardware Spec

• land's space:100mil(2.54mm)
• Onboard 32K EEPROM

NanoHat Proto-PCB

• Pin Description:

All pins except GND and PWR in the 24-Pin connector of the NanoPi NEO/Air are listed on the boards. For more details on the NanoPi NEO/Air's 24-Pin connector refer to its wiki site.
(NanoPi NEO) (NanoPi NEO Air)

Pin description next to the row of 3.3V pins:

3 Hardware Setup

FriendlyElec makes two customized female connectors for the NanoHat Proto. After these two connectors are soldered on the board it can be stacked on a NanoPi NEO/Air. Here is a hardware setup:

4 Resources

• [Schematic](Schematic - NanoHat Proto.pdf)
• [Datasheet](AT24C32D)