Difference between revisions of "Template:OfficialUbuntuCore"

Revision as of 01:28, 24 May 2022

   User Name: pi
   Password: pi

   User Name: root
   Password: fa

$ sudo apt-get update

By default "eth0" is assigned an IP address obtained via dhcp. If you want to change the setting you need to change the following file:

vi /etc/network/interfaces.d/eth0

For example if you want to assign a static IP to it you can run the following commands:

auto eth0
iface eth0 inet static
    address 192.168.1.231
    netmask 255.255.255.0
    gateway 192.168.1.1

You also need to modify the following file to add the DNS configuration:

vi /etc/systemd/resolved.conf

例如设置为192.168.1.1:

[Resolve]
DNS=192.168.1.1

Restart the systemd-resolved service with the following command:

sudo systemctl restart systemd-resolved.service
sudo systemctl enable systemd-resolved.service

To change the setting of "eth1" you can add a new file similar to eth0's configuration file under the /etc/network/interfaces.d/ directory.

sudo dpkg -i /opt/linux-headers-*.deb

@@ Line 64: / Line 64: @@
   | NanoPi-R2C-Plus
   | NanoPi-R2C =
- ===Config status LEDs===
+===Config status LEDs===
 Set the following kernel modules to be loaded automatically on boot:<br />
 <syntaxhighlight lang="bash">
@@ Line 80: / Line 80: @@
   </syntaxhighlight>
   | NanoPi-R5S
- ===Config status LEDs===
+===Config status LEDs===
 Put the following into the autorun script to associate the status leds with the ethernet interface, and you can configure it to behave in other ways by referring to these content:<br />
 <syntaxhighlight lang="bash">
@@ Line 94: / Line 94: @@
 echo eth2 > /sys/class/leds/lan2_led/device_name
 echo 1 > /sys/class/leds/lan2_led/link
- </syntaxhighlight>
+</syntaxhighlight>
   | #default =
 }}