Difference between revisions of "Lubuntu desktop"
From FriendlyELEC WiKi
Line 1: | Line 1: | ||
[[Lubuntu desktop/zh|查看中文]] | [[Lubuntu desktop/zh|查看中文]] | ||
+ | |||
+ | ===Rotate Display under Lubuntu Desktop=== | ||
+ | Firstly remove the "armsoc" configuration file: | ||
+ | <syntaxhighlight lang="bash"> | ||
+ | sudo rm -f /usr/share/X11/xorg.conf.d/20-armsoc.conf | ||
+ | </syntaxhighlight> | ||
+ | |||
+ | Create a new file "/etc/X11/xorg.conf": | ||
+ | <syntaxhighlight lang="bash"> | ||
+ | sudo vi /etc/X11/xorg.conf | ||
+ | </syntaxhighlight> | ||
+ | |||
+ | Here is the content of a typical xorg.conf file: | ||
+ | <syntaxhighlight lang="bash"> | ||
+ | Section "Monitor" | ||
+ | Identifier "Primary" | ||
+ | VendorName "FriendlyARM" | ||
+ | EndSection | ||
+ | |||
+ | Section "Device" | ||
+ | Identifier "Primary" | ||
+ | Driver "fbdev" | ||
+ | Option "fbdev" "/dev/fb0" | ||
+ | Option "Rotate" "CW" | ||
+ | EndSection | ||
+ | </syntaxhighlight> | ||
+ | The configuration file sets display to rotate 90 degrees. The rotation angle is defined by "Rotate" which can be set to one of the following values:<br /> | ||
+ | CW Rotate 90 degrees<br /> | ||
+ | UD Rotate 180 degrees<br /> | ||
+ | CCW Rotate 270 degrees<br /> | ||
+ | Save and reboot your board or start the lightdm service to make your change effective. |
Revision as of 09:11, 18 December 2017
Rotate Display under Lubuntu Desktop
Firstly remove the "armsoc" configuration file:
sudo rm -f /usr/share/X11/xorg.conf.d/20-armsoc.conf
Create a new file "/etc/X11/xorg.conf":
sudo vi /etc/X11/xorg.conf
Here is the content of a typical xorg.conf file:
Section "Monitor" Identifier "Primary" VendorName "FriendlyARM" EndSection Section "Device" Identifier "Primary" Driver "fbdev" Option "fbdev" "/dev/fb0" Option "Rotate" "CW" EndSection
The configuration file sets display to rotate 90 degrees. The rotation angle is defined by "Rotate" which can be set to one of the following values:
CW Rotate 90 degrees
UD Rotate 180 degrees
CCW Rotate 270 degrees
Save and reboot your board or start the lightdm service to make your change effective.