View source for Matrix - T-Cobbler40 for Pi/zh

[[Matrix - T-Cobbler40 for Pi|English]]
==介绍==
[[File:Matrix - T-Cobbler40 for Pi.jpg|thumb|Matrix - T-Cobbler40 for Pi]]
* 模块Matrix - T-Cobbler40 for Pi是一个方便、实用的专为创客DIY打造的40 Pin IO接口扩展模块，模块使用40 Pin排线与Pi连接，2.54mm间距的排针可直接插接在面包板上，并在面包板上搭建电路。
* 相比于使用杜邦线杂乱的连接面包板，使用T-Cobbler40 for Pi模块能更高效、快速、美观的搭建好电路，并能使用所有的Pi的40 Pin接口。

==特性==
* 1个2.54mm 40Pin排线插座
* 2个2.54mm 20Pin排针
* PCB尺寸（mm）：40x64
[[File:Matrix - T-Cobbler40 for Pi_PCB.png | frameless|550px|Matrix - T-Cobbler40 for Pi_PCB.PCB]]

* 引脚说明:
* '''40 Pin排针引脚定义：'''
{| class="wikitable"
|-
|Pin# || Name        ||Pin#  || Name        
|-
|1    || SYS_3.3V    ||2     || VDD_5V 
|-
|3    || SDA         ||4     || VDD_5V 
|- 
|5    || SCL         ||6     || GND    
|-
|7    || GPIO#7     ||8     || UART_TX
|-
|9    || GND         ||10    || UART_RX
|-
|11   || GPIO#11    ||12    || GPIO#12
|-
|13   || GPIO#13    ||14    || GND 
|-
|15   || GPIO#15    ||16    || GPIO#16
|-
|17   || SYS_3.3V    ||18    || GPIO#18 
|-
|19   || SPI_MOSI    ||20    || GND              
|-
|21   || SPI_MISO    ||22    || GPIO#22
|-
|23   || SPI_CLK     ||24    || SPI_CS
|-
|25   || GND         ||26    || GPIO#26
|-
|27   || GPIO#27    ||28    || GPIO#28
|-
|29   || GPIO#29    ||30     || GND             
|-
|31   || GPIO#31    ||32     || GPIO#32       
|-
|33   || GPIO#33    ||34     || GND             
|-
|35   || GPIO#35    ||36     || GPIO#36  
|-
|37   || GPIO#37    ||38     || GPIO#38
|-
|39   || GND         ||40     || GPIO#40  
|}

==硬件连接==
===连接NanoPi M1===
连接M1和面包板，并在面包板上搭建电路。<br>
注意：排线红边对应M1的Pin1脚。
参考下图连接模块：<br>
[[File:Matrix-T-Cobbler40_nanopi_m1.jpg|frameless|600px|Matrix-T-Cobbler40_nanopi_m1]]

==相关资料==
*[Schematic]([http://wiki.friendlyarm.com/wiki/images/1/1f/SCHEMATIC_T-Cobbler40_for_Pi.pdf Schematic - T-Cobbler40 for Pi.pdf])