Difference between revisions of "LED"
From FriendlyELEC WiKi
(Created page with "查看中文") |
(updated by API) |
||
| (3 intermediate revisions by one other user not shown) | |||
| Line 1: | Line 1: | ||
[[LED/zh|查看中文]] | [[LED/zh|查看中文]] | ||
| + | |||
| + | ==H3/H5== | ||
| + | The onboard status LEDs are all heartbeat status by default, and you can check the relevant settings with the following command： | ||
| + | <syntaxhighlight lang="bash"> | ||
| + | $ cat /sys/class/leds/status_led/trigger | ||
| + | none rc-feedback rfkill-any kbd-scrolllock kbd-numlock kbd-capslock kbd-kanalockk | ||
| + | kbd-shiftlock kbd-altgrlock kbd-ctrllock kbd-altlock kbd-shiftllock kbd-shiftrll | ||
| + | ock kbd-ctrlllock kbd-ctrlrlock usbport usb-gadget usb-host mmc1 mmc2 mmc0 timerr | ||
| + | oneshot disk-activity ide-disk mtd nand-disk [heartbeat] backlight gpio cpu cpuu | ||
| + | 0 cpu1 cpu2 cpu3 default-on transient flash torch panic netdev rfkill0 stmmac-0:: | ||
| + | 00:1Gbps stmmac-0:00:100Mbps stmmac-0:00:10Mbps | ||
| + | </syntaxhighlight> | ||
| + | |||
| + | [heartbeat]means that the default triggering mode of the LED is heartbeat.<br> | ||
| + | Example: Execute the following command to keep the LED always on： | ||
| + | <syntaxhighlight lang="bash"> | ||
| + | echo default-on > /sys/class/leds/status_led/trigger | ||
| + | </syntaxhighlight> | ||
Latest revision as of 11:05, 9 September 2021
H3/H5
The onboard status LEDs are all heartbeat status by default, and you can check the relevant settings with the following command：
$ cat /sys/class/leds/status_led/trigger none rc-feedback rfkill-any kbd-scrolllock kbd-numlock kbd-capslock kbd-kanalockk kbd-shiftlock kbd-altgrlock kbd-ctrllock kbd-altlock kbd-shiftllock kbd-shiftrll ock kbd-ctrlllock kbd-ctrlrlock usbport usb-gadget usb-host mmc1 mmc2 mmc0 timerr oneshot disk-activity ide-disk mtd nand-disk [heartbeat] backlight gpio cpu cpuu 0 cpu1 cpu2 cpu3 default-on transient flash torch panic netdev rfkill0 stmmac-0:: 00:1Gbps stmmac-0:00:100Mbps stmmac-0:00:10Mbps
[heartbeat]means that the default triggering mode of the LED is heartbeat.
Example: Execute the following command to keep the LED always on：
echo default-on > /sys/class/leds/status_led/trigger
