BakeBit - Button

From FriendlyELEC WiKi
Revision as of 07:46, 17 April 2017 by Tzs (Talk | contribs) (Observation)

Jump to: navigation, search

查看中文

1 Introduction

Button
  • The BakeBit - Button is an instant button module and it is used to detect button events. When the button is released the module goes back to its default state.
  • If the button is not pressed the module will output high otherwise it will output low.

2 Hardware Spec

  • Standard 2.0mm pitch 4-Pin BakeBit interface
  • Digital output
  • PCB dimension(mm): 20 x 24

BakeBit - Button.PCB

  • Pin Description:
Pin Description
GND Ground
5V Supply Voltage 5V
NC Not Connected
SIG Signal

3 Code Sample: Button And Buzzer

A BakeBit - Buzzer module is needed in this test case.

3.1 Hardware Setup

Connect the buzzer module to the NanoHat Hub's D3 and the button module to the NanoHat Hub's D4:

Button And Buzzer-1.jpg Button And Buzzer-2.jpg

3.2 Source Code

import time
from bakebit import *
import math
 
buzzer_pin = 3		#Port for buzzer
button = 4		#Port for Button
 
pinMode(buzzer_pin,"OUTPUT")	# Assign mode for buzzer as output
pinMode(button,"INPUT")		# Assign mode for Button as input
while True:
	try:
		button_status= digitalRead(button)	#Read the Button status
		if button_status:	#If the Button is in HIGH position, run the program
			analogWrite(buzzer_pin,0)						
			print "\tOff"			
		else:		#If Button is in Off position, print "Off" on the screen
			analogWrite(buzzer_pin,127)
			print "Buzzing"			
	except KeyboardInterrupt:	# Stop the buzzer before stopping
		digitalWrite(buzzer_pin,0)
		break
	except (IOError,TypeError) as e:
print("Error")

Github

3.3 Run Code Sample

Before you run the code sample you need to follow the steps in bakebit tutorial to install the BakeBit package.
Enter the "BakeBit/Software/Python" directory and run the "bakebit_prj_Button_And_Buzzer.py" program:

cd ~/BakeBit/Software/Python
sudo python bakebit_prj_Button_And_Buzzer.py

3.4 Observation

When the button is clicked the buzzer will beep and if it is clicked again the buzzer will be silent.

4 Resources

5 Update Log

5.1 December-12-2016

  • Released English version

5.2 Jan-19-2017

  • Renamed "NEO-Hub" to "NanoHat-Hub"

5.3 Jan-20-2017

  • Renamed "NanoHat-Hub" to "NanoHat Hub"