Matrix - Relay/zh

From FriendlyELEC WiKi
Revision as of 08:53, 7 August 2015 by Yftan (Talk | contribs) (编译并运行示例)

Jump to: navigation, search

English

1 Introduction

Relay

这是一个单刀双掷继电器,线圈电压为直流5V,触点电流可达10A,适合驱动直流或交流大功率负载。NO为常开触点,NC为常闭触点,COM为公共触点。当向S引脚施加高电平,继电器线圈导通,此时NO触点断开,NC触点闭合。

2 特性

  • 1 Form C
  • 5V线圈电压,控制信号为3.3/5V
  • 触点电流可达10A
  • LED指示
  • 2.54mm排针接口,接线方便,通用性强

3 使用方法

3.1 连接

  • 连接到Tiny4412 SDK (1506)
将配件S针脚连接到GPIO PIN1, V接5V,G接地

3.2 Linux下的C示例

#include <stdio.h>
#include <string.h>
#include "libfahw.h"
 
int main(int argc, char ** argv)
{
    char *status = "off";
    if (argc != 2) {
        printf("Set relay on\n");
    } else {
        status = argv[1];
        printf("Set relay %s\n", argv[1]);
    }
 
    int pin = TINY4412_GPIO_PIN1;
    int ret = -1;
    if ((ret = exportGPIOPin(pin)) != 0) {
        printf("exportGPIOPin(%d) failed!", pin);
    }
    if ((ret = setGPIODirection(pin, GPIO_OUT)) != 0) {
        printf("setGPIODirection(%d) failed", pin);
    }
 
    if (strcmp(status, "on") == 0) {
        ret = setGPIOValue(pin, GPIO_LOW);
    } else {
        ret = setGPIOValue(pin, GPIO_HIGH);
    }
    return ret;
}

3.3 Compile and Run

git clone http://github.com/friendlyarm/fa-hardware.git
cd fa-hardware
cd demo
cd matrix-relay
make

Copy your compiled bin to your board and you are ready to go.

4 Resources